The Grip series is by far our best selling chain. Why do people like them so much?
Diamond pattern for better traction
Ease of installation
Rugged and Durable
Affordable
Link size for the Grip 4x4 is 5.5mm and is too thick of a chain to meet class "S" clearance standards when required.
Link size for the Compact Grip is 3.5mm and meets class "S" clearance standards.
To install these chains, open the bag and remove the chains. Detach the cable from its connectors
and shake the chain so that it all dangles loose. Then take the long thin yellow chain and make certain
it is detached from all other devices. Lay the chain on the ground with the plastic covered cable
forming a half moon with both ends facing the car. Push one end around the tire and grab it with your
other hand so that the plastic coated cable is now wrapped around the wheel. Lift both ends up and secure
the cable at the top most part of the tire behind the tire. Secure the
hook to the hook ring at the top front of the tire facing you and fit the chain along both sides of the tire.
Now take the long thin yellow chain at the bottom
and run it through the brass colored connector hole and sinch it back for tightness. Now run the long thin
yellow chain through the thin yellow metal loop and attach the long thin yellow chain up to the blue chain
near the top as tighly as you can get it.
These chains take about two minutes to install when you know what your doing.
The Grip 4x4 is priced $98 per set. Shipping not included. One set is for two tires.
